Tuesday, May 2, 2017

WATER HARDNESS & PRECIPITATION SOFTENING - The water is treated with lime or a combination of lime and soda ash (carbonate ion). These chemicals react with the hardness and natural alkalinity in the water to form insoluble compounds. The compounds precipitate and are removed from the water by sedimentation and, usually, filtration.

Water Hardness & 
Precipitation Softening
Precipitation softening processes are used to reduce raw water hardness, alkalinity, silica, and other constituents.
This helps prepare water for direct use as cooling tower makeup or as a first-stage treatment followed by ion exchange for boiler makeup or process use.
The water is treated with lime or a combination of lime and soda ash (carbonate ion). These chemicals react with the hardness and natural alkalinity in the water to form insoluble compounds.
The compounds precipitate and are removed from the water by sedimentation and, usually, filtration.
Waters with moderate to high hardness and alkalinity concentrations (150-500 ppm as CaCO3) are often treated in this fashion.
In almost every raw water supply, hardness is present as calcium and magnesium bicarbonate, often referred to as carbonate hardness or temporary hardness.
These compounds result from the action of acidic, carbon dioxide laden rain water on naturally occurring minerals in the earth, such as limestone. For example:
CO2
+
H2O
=
H2CO3

carbon dioxide
water
carbonic acid

H2CO3
+
CaCO3 ¯  
=
Ca(HCO3)2
carbonic acid
calcium carbonate
calcium bicarbonate
Hardness may also be present as a sulfate or chloride salt, referred to as non-carbonate or permanent hardness.
These salts are caused by mineral acids present in rain water or the solution of naturally occurring acidic minerals.
The significance of "carbonate" or "temporary" hardness as contrasted to "non-carbonate" or "permanent" hardness is that the former may be reduced in concentration simply by heating.
In effect, heating reverses the solution reaction: 
Ca(HCO3)2
+
Heat
=
CaCO3 ¯
+
H2O
+
CO2
calcium bicarbonate
calcium carbonate
water
carbon dioxide
Reduction of non-carbonate hardness, by contrast, requires chemical addition.
A combination of lime and soda ash, along with coagulant and flocculant chemicals, is added to raw water to promote a precipitation reaction. This allows softening to take place.
Precipitation softening accomplished at ambient temperatures is referred to as cold lime softening.
When hydrated lime, Ca(OH)2, is added to the water being treated, the following reactions occur:  
CO2
+
Ca(OH)2
=
CaCO3 ¯
+
H2O
carbon dioxide
calcium hydroxide
calcium carbonate
water
Ca(HCO3)2
+
Ca(OH)2
=
2CaCO3 ¯
+
2H2O

calcium bicarbonate
calcium hydroxide
calcium carbonate
water

Mg(HCO3)2
+
2Ca(OH)2 
=
Mg(OH)2 ¯ 
+
2CaCO3 ¯ 
+
2H2O

magnesium bicarbonate
calcium hydroxide
magnesium hydroxide
calcium carbonate
water

If the proper chemical control is maintained on lime feed, the calcium hardness may be reduced to 35-50 ppm.
Magnesium reduction is a function of the amount of hydroxyl (OH-) alkalinity excess maintained. 
Non-carbonate or permanent calcium hardness, if present, is not affected by treatment with lime alone.
If non-carbonate magnesium hardness is present in an amount greater than 70 ppm and an excess hydroxyl alkalinity of about 5 ppm is maintained, the magnesium will be reduced to about 70 ppm, but the calcium will increase in proportion to the magnesium reduction.
For example, in cold lime treatment of a water containing 110 ppm of calcium, 95 ppm of magnesium, and at least 110 ppm of alkalinity (all expressed as calcium carbonate), calcium could theoretically be reduced to 35 ppm and the magnesium to about 70 ppm.
However, an additional 25 ppm of calcium would be expected in the treated water due to the following reactions:
MgSO4
+
Ca(OH)2
=
Mg(OH)2 ¯ 
+
CaSO4
magnesium sulfate
calcium hydroxide
magnesium hydroxide
calcium sulfate
MgCl2
+
Ca(OH)2
=
Mg(OH)2 ¯ 
+
CaCl2
magnesium chloride
calcium
magnesium hydroxide
calcium chloride
To improve magnesium reduction, which also improves silica reduction in cold process softening, sodium aluminate may be used.
The sodium aluminate provides hydroxyl ion (OH-) needed for improved magnesium reduction, without increasing calcium hardness in the treated water.
In addition, the hydrolysis of sodium aluminate results in the formation of aluminum hydroxide, which aids in floc formation, sludge blanket conditioning, and silica reduction. The reactions are as follows:
Na2Al2O4
+
4H2O
=
2Al(OH)3 ¯ 
+
2NaOH

sodium aluminate
water
aluminum hydroxide
sodium hydroxide

Mg
[

SO4
]
+
  2NaOH
=
Mg(OH)2¯
+
[

Na2SO4
]
RELATED POSTS:
.
Hard Vs. Soft Water 
Explained
CLICK HERE . . .
THE ION EXCHANGE 
PRINCIPLE
CLICK HERE . . .
POULTRY WATER 
QUALITY





CLICK HERE . . .

.

PURICAR
INDUSTRIAL 
ENTERPRISES 



GS Series Submersible Pump





No comments:

Post a Comment